RINATO Wall Light Double: Sizing and Placement for Wide Hallways

Quick answer

For a wide hallway, mount the RINATO Wall Light Double at eye level (60-66 inches from the floor) and space the fixtures 6-8 feet apart to avoid overlighting or dark gaps.

Step-by-step placement guide

1. 1. Measure your hallway width and length: Note the exact width (distance between walls) and the total length of the hallway. For hallways wider than 5 feet, the RINATO Wall Light Double’s dual shades can cover up to 4 feet of wall width per fixture. For hallways 5-7 feet wide, one fixture every 6-8 feet works well. For hallways wider than 7 feet, consider using two fixtures on opposite walls, staggered to avoid glare. Checkpoint: If your hallway is under 4 feet wide, a single-shade wall light may be more appropriate to avoid overwhelming the space.
2. 2. Mark the mounting height: Mount the fixture so the center of the shades sits 60-66 inches above the finished floor. This places the light at average eye level, reducing direct glare while still illuminating the floor and walls. In hallways with very high ceilings (over 10 feet), you can raise the mount to 72 inches, but keep the fixture at least 6 inches below the ceiling to maintain the intended visual balance. Common mistake: Mounting too high (above 72 inches) turns the fixture into a ceiling washer and leaves the lower wall dark.
3. 3. Determine horizontal spacing: Space each RINATO Wall Light Double 6-8 feet apart along the hallway. Start the first fixture 2-3 feet from the end wall to avoid a harsh cutoff. For example, in a 20-foot hallway, install three fixtures at 3, 10, and 17 feet from one end. The overlapping light cones from the opposing shades will create a continuous wash of light without hot spots or dead zones. Checkpoint: If your hallway has doors or alcoves, adjust spacing so fixtures are centered between door frames for a symmetrical look.
4. 4. Consider finish and leather color for visual flow: The RINATO Wall Light Double is available in multiple metal finishes and leather trim colors. For a wide hallway, choose a finish that complements existing hardware (e.g., brass with warm-toned decor, stainless steel with cool tones). The leather strip adds a personal touch—opt for a color that either matches or subtly contrasts with the wall paint to make the fixture stand out without clashing. Common mistake: Choosing a leather color that blends into the wall can make the fixture look flat; a slight contrast (e.g., tan leather on a gray wall) adds depth.
5. 5. Wire and install with a dimmer for flexibility: Because the RINATO Wall Light Double uses fixed shades, you cannot adjust the beam angle after installation. A dimmer switch gives you control over brightness, allowing you to lower the light level for a cozy evening ambiance or raise it for task lighting. Ensure the dimmer is compatible with the bulb type you plan to use (check the fixture’s specifications). Checkpoint: Test the dimmer with the bulbs before finalizing installation to confirm smooth dimming without flicker.

Product facts

• RINATO WALL LIGHT DOUBLE: The Wall Light Double features two signature stainless-steel shades fixed asymmetrically and opposing each other on its metalwork frame. This fixed dual-shade design provides broad, even illumination along a hallway without the need for adjustable heads, but it requires precise placement before installation.